Treat the roof as an assembly
Lightweight fill may be considered to form levels or falls within a roof build-up. Its role must be distinguished from the structural slab, the waterproofing system and the final protection or finish. Showing these layers in a diagram does not determine their sequence for every roof.
Engineered lightweight insulating concrete roof systems have their own specifications and covering arrangements. Published properties or roofing times for one such system should not be transferred to a project-specific CLC fill. [source]
Begin with a roof plan showing outlets, high points, thresholds, penetrations and movement joints. Record the structural designer's permitted loads and the waterproofing supplier's requirements for the receiving substrate. Resolve which trade owns each interface.
Calculate volume from measured geometry
For a uniform layer, volume equals area multiplied by depth in metres. For a rectangular area with a uniform planar fall, the average of the two end depths can represent the average depth. For multi-directional falls, crickets, steps or irregular boundaries, divide the roof into zones and calculate each zone from its geometry.
In an illustrative 100 m² rectangular zone, the fill varies uniformly from 50 to 100 mm. Average depth is (50 + 100) ÷ 2 = 75 mm, or 0.075 m. Net fill volume is 100 × 0.075 = 7.5 m³.
These depths demonstrate arithmetic only. They are not recommended minimum thicknesses or a drainage design. A level survey, the selected formulation and the approved roof detail establish the actual depths. Add any agreed placing allowance separately so the net geometry remains visible.
Use the correct density for the load question
A fresh fill load and a dry material property answer different questions. For a construction-stage check, obtain the applicable fresh density and account for the placing operation. For the permanent design, use the condition and values required by the designer. Do not infer either value from the word “lightweight.”
For arithmetic only, assume a fresh density of 1,000 kg/m³ at the example average depth of 0.075 m. Fresh fill mass is 75 kg/m². Multiplying by 9.81 and dividing by 1,000 gives approximately 0.736 kN/m² (0.736 kPa).
The assumed density is not a CELBLOC rating. The result excludes toppings, membranes, protection, stored materials, personnel, equipment and other construction or service loads. It does not establish structural adequacy. Local thickness peaks also need consideration; an average load is not the whole design check.
Agree the release to waterproofing
Cured does not necessarily mean ready to receive a moisture-sensitive covering. Substrate acceptance can involve moisture, strength, surface condition and compatibility. Concrete slab guidance highlights how residual moisture and covering requirements can conflict with fast programmes. [source]
Agree the actual test or inspection method with the selected membrane or finish supplier before placing the fill. Specify how the work is protected, who checks levels and outlets, who accepts the substrate and who releases the next trade. Avoid a generic promise that every roof can be covered after a fixed number of days.
Prepare a complete enquiry
- Roof plan, level survey and the proposed drainage arrangement.
- Area and minimum, maximum and average fill depths by zone.
- Required load basis, material criteria and testing requirements.
- Access, mixing location, placing distance and working sequence.
- Waterproofing system, substrate acceptance and protection scope.
- Net volume, separately stated allowance and programme.
Request separate scope lines for fill production and placing, testing, curing or protection, waterproofing and final finishes. This makes quotations comparable and reduces uncertainty at handover.
Sources & scope
Primary references consulted for this guide. Worked examples are illustrative. Apply the project specification and the appropriate adopted test methods.
- National Roof Deck Contractors Association · LWIC questions
Engineered lightweight roof systems; its system-specific values and roofing times are not transferred to SEED fill.
- NRMCA CIP 28 · Concrete slab moisture
Moisture-sensitive coverings and substrate acceptance; no generic release time adopted.
