SEED Materials

The Materials field guide / Volume 01

Understand it.
Specify it.
Build it well.

Ten practical guides to the decisions behind a wall, a floor and a concrete operation. Clear drawings. Worked numbers. Sources you can check.

Explore the guides ↓
Blue batching plant and slender silos in a generic Pakistan site setting
Concrete systems / Visual study
10

Guides from material selection
to production records.

Change a number.
See what changes.

Four interactive explanations connect the material to the decisions on site.

CLC density & strength

See nominal strength targets and dry block weight change with density.

Roof-fill volume & load

Translate levels into quantity and average fresh fill load.

Aggregate moisture

Balance wet sand and water without changing the intended solids.

Plant, fleet & placing

Find the limiting stage in an illustrative production system.

Blocks & walls

03 guides
01

CLC, AAC or clay brick: compare the complete wall

A practical way to compare production routes, evidence, installed cost and wall interfaces without treating different materials as equivalents.

Read the guide
02

How to calculate CLC blocks for a wall

Measure the wall, deduct openings and calculate both block lengths with transparent allowances, units and rounding.

Read the guide
03

Planning CLC block installation: joints, bond and finishes

Use the approved CELBLOC guidance to coordinate the first course, jointing system, block overlap and interfaces before work starts.

Read the guide

Floors & roofs

01 guide
04

Lightweight roof fill: levels, loads and waterproofing

Calculate a fill volume, distinguish fresh load from dry properties, and coordinate drainage and the roof covering as one assembly.

Read the guide

Concrete production

06 guides
05

Selecting a concrete batching plant for the actual pour

Work from demand and logistics to mixer capacity, storage, utilities and commissioning. Includes an illustrative production bottleneck calculation.

Read the guide
06

Concrete mix development: from requirements to production trials

Turn a performance brief into a controlled trial programme, with traceable materials, measured results and a clear release decision.

Read the guide
07

Aggregate moisture correction: a worked batch calculation

Follow one sand fraction from oven-dry mass to SSD design mass and wet batch mass, then correct the water addition.

Read the guide
08

Slump and strength: two tests, two different questions

Understand what a fresh-concrete consistency test tells you, why it cannot replace a strength result, and how to record adjustments.

Read the guide
09

Hot-weather concreting: protect the pour, then cure it

Plan for temperature, wind, humidity and exposure, and distinguish early evaporation protection from the curing that follows.

Read the guide
10

Concrete testing: connect the batch to the result

Build a practical record chain from mix revision and delivery through sampling, curing, laboratory results and project decisions.

Read the guide